Détérrage !!
extrait de :
SV PORTAL
Switch ignition on. Press left button one or twice (SELect) so that ODO total distance from new is shown. Units will be according to where the bike was supplied.
Switch ignition off.
Now press and hold both buttons down at the same time. Thats the SELect on the left and ADJust on the right.
Switch ignition back on while still holding those two buttons down.
Wait a few seconds - perhaps as long as ten - and your speedometer will have changed to the alternative speed unit.
I never had this change the temperature between C and F. Must be another tweak for this.
The ODO will convert directly between total recorded distance in either km or miles and back without loss.
You will probably find the time clock needs setting again.
The recorded TRIP A and Trip B distances don't convert to the new units. These reset what was recorded to zero in most cases but start to record in the new units.